SECTION 4—FRONT RIGGINGS
30
Replacing Heel Loop
NOTE:
For
this
procedure,
refer
to
1. Pull
the
cam
lock
lever
up
to
unlocked
position.
2. Perform
one
of
the
following
as
shown
in
Detail
ʺ
A
ʺ
.
• Footplates
with
Spring
Buttons:
Push
in
the
release
buttons
and
remove
the
footplate
assembly
from
the
front
rigging
support.
• Bolt
‐
In
‐
Place
Footplates:
i. Using
a
screw
driver
to
hold
the
threaded
rivet
in
position,
remove
the
button
head
screw
from
the
threaded
rivet.
ii. Remove
the
threaded
rivet
and
button
head
screw
securing
the
footplate
assembly
to
the
front
rigging
support.
3. Remove
the
mounting
screw,
spacer
and
locknut
that
secure
the
heel
loop
to
the
footplate.
4. Remove
existing
heel
loop
from
slide
tube.
5. Install
new
heel
loop
onto
slide
tube.
6. Install
the
mounting
screw,
spacer
and
locknut
to
secure
the
heel
loop
to
the
footplate.
Tighten
until
the
spacer
is
secure.
7. Insert
the
lower
footrest
assembly
into
the
upper
footrest
assembly
to
desired
height.
8. Perform
one
of
the
following
as
shown
in
Detail
ʺ
A
ʺ
:
• Footplates
With
Spring
Buttons:
Ensure
that
the
release
buttons
fully
protrude
from
holes
on
both
sides
of
the
upper
footrest
support.
• Bolt
‐
In
‐
Place
Footplates:
i. From
the
outside
of
the
swingaway
front
rigging,
insert
the
threaded
rivet
through
both
the
front
rigging
support
and
the
footplate
assembly.
ii. From
the
inside
of
the
swingaway
front
rigging,
insert
the
button
head
screw
through
the
appropriate
adjustment
hole
and
thread
into
the
threaded
rivet.
iii. Using
a
screwdriver
to
hold
the
threaded
rivet
in
position,
securely
tighten
the
button
head
screw.
Torque
to
32
in
‐
lbs.
9. Rotate
cam
lock
lever
down
to
locked
position.
