TROUBLESHOOT
-
Remote doesn’t send any signal – we do not see anything happening when pressing the trigger and gesture button
1-
Check battery level or change batteries
2-
Re – pair dongle and remote with step 2
3-
Press volume buttons to see if it raises the volume, if yes, then press the sequence key to go into the desired
mode. If not, recheck step 1 and 2.
-
Stuck keys: press volume button to see if it raises the volume
-
Calibration: remote are precalibrated, but it can happen in pointing mode, that the gyro drift, put on the table key down
until you see the pointing stop moving – then to secure the current calibration press green button then 1.
-
If it is the first time that you use your remote, it is possible to observe a drift on your gyro. If so, just put the remote on a
table key down and wait until you see the pointing stop moving.
-
If the MoveaTV platform doesn’t stop correctly, it can happen that some programs don’t shut down correctly. If it is the
case, you will observe some error when you start the MoveaTV platform. To fix those errors, you can manually terminate all
the instance of the sms, MoveLab2, GoogleChrome, XBMC, sma or smselector that could appear on the task manager.
Page
18
of
19
