GETTING STARTED
1-
Place 3 AAA batteries in the back of the remote
2-
Insert USB dongle into available USB port
3-
Pair remote with dongle :
•
Regular dongle:
•
Press the connect button on the remote,
•
once the yellow LED is blinking,
•
press the blue button on remote – Dongle and remote are paired once
the yellow light stays on.
•
Nano dongle:
•
Plug the nano dongle in an available USB port and wait about 5 seconds
for the dongle to be detected by the computer, then press the blue button on your remote.
•
The cursor should move on the screen to the right, then left, then right again and finally left,
the remote and dongle are paired.
4-
Install MoveaTV Evaluation kit by clicking on the Setup icon on your desktop. Accept all software installation, including
Trackmania.
MoveaTV application should open automatically after installation, if not, double click on the application icon on your
desktop.
Activate Embedded In-Air Pointing Mode
When the embedded in-air pointing is activated, gesture recognition is not available; all the data fusion is processed only on the
remote and does not leverage the host MoveaTV platform.
Double click on the motion button to activate the embedded pointing for in-air control to move the cursor on screen.
When first connecting, the remote will be in pointing mode. Once the MoveaTV application is launched, please switch to raw data
mode.
Activate Raw Data Mode
When entering the raw data mode, sensor signals processing is not embedded on the remote but enabled on the host device
through the MoveaTV application. This application leverages Movea’s SmartMotion Server capabilities enabling raw data analysis,
in-air pointing and advanced gesture recognition. Raw signals will be sent from the remote to the MoveaTV application, this mode is
therefore used for all applications within the MoveaTV application.
1.
Launch MoveaTV application by double clicking on the icon
Press the green “9” to enable the raw data mode
2.
Ensure motion trigger is locked on by double clicking the Motion button if necessary
3.
To try gesture recognition, open the Tutorial within press the motion button, make the intended gesture, and release the
button
Press button to pair the remote
Page
3
of
19
