4
/
7
1)
A touch sensor is used to detect wearing state (worn/removed)
2)
A soft “beep” could be heard when the earphones are detected.
3)
When removing earphones, please try to hold them at handles to prevent misjudgment.
4)
After removal of either one earphone, music playing will be paused. Put back to resume
playing.
1)
Close the charging case, and the approximate power status will be displayed:
2)
·
LED lights off: charging case cannot charge the earphones.
3)
·
LED blinks in red: earphones could be charged only once.
4)
·
LED blinks in green: earphones could be charged over twice.
5)
·
LED remains green: case battery is fully charged.
6)
After showing the power status, the earphones will be automatically charged, and LED
indicator will be off.
Note:
The above data are measured based on the new battery in the charging case in laboratory
condition. Due to the characteristics of lithium batteries, the battery capacity may undergo
attenuation during use, which may lead to a decrease in the number of charges.
1) Use the enclosed charging cable to charge the case battery. Red LED flashes to indicate that it
is being charged while constant green LED means the battery is fully charged.
2) LED goes out automatically after pulling out the charging cable.
Power Indication on Charging Case
Charging the Case
Earphone Operation
Wear Detection
