40
INSTALLATION AND ASSEMBLY
aV100 extract air system – Avio N 100
•
Installation and operating instructions
NOTE
Over-shortened cable.
Cable cannot be reconnected after disassembly for maintenance work!
►
Do not excessively shorten the cable.
Ö
Ö
The Avio N 100 extractor fan is inserted and the power cable is connected.
TIP
Check functioning of the aV100 extract air system immediately after connecting the Avio N 100
extractor fan. To do this, connect the Avio N 100 to the power supply and activate the operating
element (light switch, switch or pushbutton). Subsequently disconnect the extract air system
from the power supply again.
►
Connect the shortened power cable (16),
according to the wiring diagram, to the
terminal block (15),
see section 4: Electrical connections ‒ termi
-
nal assignment, wiring diagrams.
15
16
Ls
L
N
►
Remove the cable sheath (13) of the power
cable (12).
►
Shorten the wires (14) of the power cable,
ensuring that they can reach the power supply
terminal (11) on the PCB of the fan casing.
Take care not to
over-shorten the power
cable (12).
►
Strip the insulation (14) of the
power cable (12).
11
13
12
14
►
Screw the fan casing (9) to the four corner
boreholes (10) on the interior wall.
10
9