5
USER AND SAFETY INSTRUCTIONS
5
iV-Smart+ ventilation device | Installation instructions
1.2 Safety instructions
The installation instructions are part of your iV-Smart+ ventilation device and must be available at
all times (see www.inventer.eu/downloads). When handing the system to a third party, the infor-
mation regarding access to the installation instructions must be handed over also.
Before performing any work on the device/system, read the installation instructions carefully and
observe all notices that refer to the installation process in this section.
Also note the safety instructions that precede the described handling instructions. Non-obser-
vance of safety instructions could result in injury and/or property damage.
These installation instructions only cover the standard variant (in the further text "variant
standard") of the iV-Smart+ ventilation device. Information on the variants can be found in the
separate installation instructions for the respective components.
Intended use
The ventilation device is designed to ventilate dwellings and similar residential spaces and other
areas where people spend time, e.g. living rooms and bedrooms, offices, basements and attics. It
is controlled via an inVENTer system control device (hereinafter referred to as the "controller").
General information
• Always observe the relevant standards, regulations and guidelines when installing the
equipment / system. In particular also applicable building regulations, fire safety regulations and
accident prevention regulations of the employers' liability insurance association.
• Use the device/system exclusively for the applications that are described in this documentation
and only in conjunction with components that are recommended, authorised and described by
inVENTer GmbH in this documentation.
Changes or modifications to the device/system are not permitted.
• Your ventilation system is exclusively designed for use in ambient temperatures between
-20 and 50°C.
• Trouble-free and safe operation of the device / system depends on proper transportation,
proper storage and installation, as well as careful operation and cleaning / care.
• The ventilation device is based on the free movement of air between individual pairs of ventila-
tion devices. Therefore, internal doors must not have air-tight seals. Provide suitable air transfer
measures to create a room network (cross ventilation).
Installation and assembly
•
CAUTION:
The system may only be installed by qualified personnel.
• Before starting work, you should have a project plan showing the number of ventilation devices,
the location of the ventilation devices, the ventilation principle (cross ventilation, single room
ventilation, extract ventilation) and the associated controllers. The exact positioning of the indi-
vidual devices and control devices must be checked at the installation site and, if
necessary, adapted to the local conditions with the involvement of the responsible planner or
user. For optimum functionality, it is recommended to install the device at an appropriate place
in the upper wall area.
•
WARNING:
For joint operation with fireplaces, safety measures must be taken to prevent a
negative pressure from developing in the building. The responsible chimney sweep and/or
building planner decides which measures need to be carried out.
