25
INSTALLATION AND ASSEMBLY
Ventilation device iV14-MaxAir
•
Installation and operating instructions
►
Create the four boreholes with Ø 8 mm,
min. 50 mm deep.
►
Fix the sealing tape, 9 mm, on the exterior wall
side and all around
• Along the guide on the base plate.
• Flush to the opening for the wall sleeve.
Be careful not
to seal the fixing holes.
TIP:
Do not apply the sealing tape until immediately
before installing the base plate. This prevents
the sealing tape from swelling too much and makes
installation easier.
►
Insert the rawl plugs into the boreholes.
►
Screw the weather protection hood base plate
into the rawl plugs using 4 screws and washers.
TIP:
When attaching the base plate of the Flex
weather protection hood to exterior walls with insulation
or when using the wall installation block/Simplex wall
installation system, use wallplugs for insulation for
fixing purposes. These are not included in the scope
of supply, they are available as an option.
►
Slide the base plate onto the projecting wall sleeve.
►
Level the base plate using a spirit level.
►
Mark the four boreholes:
Outer boreholes (blue arrow): Masonry.
Inner boreholes (green arrow): Simplex.
ø 8 mm
Simplex
4 x