12
USER AND SAFETY INSTRUCTIONS
Ventilation device iV14-MaxAir
•
Installation and operating instructions
2.3
Control elements
sMove controller
The sMove controller is an electronic programming unit for controlling
up to four iV14-MaxAir ventilation devices. It is characterised by
a timeless and slim design, easy installation and a simple touch-based
operating concept.
It is available in a flat and standard version:
In contrast to the flat version, in addition to pause mode, the standard
version provides the option to switch off the ventilation device completely.
The connected ventilation devices can be controlled in the following modes:
• Heat recovery
• Pause timer
• Ventilation
•
Off (only sMove standard version)
MZ-Home controller
The MZ-Home controller is an electronic programming unit for controlling up to eight iV14-MaxAir
ventilation devices.
It features Clust-Air technology (multi-zone control), easy installation,
touch operation and a wide variety of possible uses.
The MZ-Home controller consists of a programming unit and at least one
(optionally up to a maximum of four) Clust-Air module(s). Each Clust-Air
module can control up to two iV14-MaxAir ventilation devices per zone
within the accommodation unit. This allows the MZ-Home controller
to provide individual ventilation for up to four different areas (ventilation
zones) within one accommodation unit. For each zone, the operating
mode and output level can be set manually or via a 7-day timer.
The connected ventilation devices can be controlled in the following modes:
• Heat recovery
• Ventilation
•
Dehumidification
•
Off / Pause function
The sMove and MZ-Home controllers can be expanded with additional sensors.
An external interface allows the connection of a potential-free switching contact or integration
into an existing home automation system via an analogue input.
For detailed information, see the controller's installation and operating instructions.
