6
USER AND SAFET Y INSTRUCTIONS
inVENTer PAX standard set
•
Installation and operating instructions
1.2
Safety instructions
These installation and operating instructions are part of the ventilation unit and must be
permanently available. When handing the equipment/system to a third party, the installation and
operating instructions must be handed over also. Before performing any work on the system,
read the installation and operating instructions carefully and observe all information regarding
installation, commissioning and maintenance contained in this section. Also note the safety
instructions that precede the described handling instructions.
Non-observance of safety warnings could result in injury and/or property damage.
Intended use
The ventilation device is designed to ventilate dwellings and similar residential spaces.
Observe the relevant standards, regulations and guidelines, especially the applicable building
codes and fire and accident prevention regulations issued by the respective trade association.
Use the equipment/system exclusively for the applications that are described in this
documentation and only in conjunction with components that are recommended, authorised
and described by inVENTer GmbH in this documentation. Changes or modifications to the
equipment/system are not permitted.
• Trouble-free and safe operation of the equipment depends on proper transportation, proper
storage and installation as well as careful operation and maintenance.
• Before starting work, you should have a ventilation concept from which the number of
ventilation units and their position can be determined.
• The ventilation system may only be commissioned after completion of the construction project.
• The volume of supply air should match the volume of extract air. We recommend an external air
supply for inVENTer PAX. This may be realised by appropriate overflow measures: an air gap of
about 10 mm below the door, unscrew the hinges by 5 mm, use a ventilation grille or similar.
• DANGER:
When laying the power supply cable, observe the requirements of protection class II.
• DANGER:
Ensure that the power supply (voltage, frequency and phase) correspond to the
specifications on the type plate.
• DANGER:
The inVENTer PAX is designed for fixed installation with permanent cabling.
• CAUTION:
Installation and electrical connection may only be performed by qualified and
trained personnel.
• CAUTION:
Operation and/or maintenance of the device must not be carried out by children
and/or persons who are not fully capable of doing so due to their physical, sensory or mental
capabilities, inexperience or lack of knowledge. Young children should be supervised to
ensure that they do not play with the device.
• Before performing cleaning or maintenance tasks, disconnect the power supply and put on
gloves.
• NOTICE:
Install the wall sleeve outside airtight and inside vapour tight into the air resistance
layer. Material must be provided by the customer. Consult your planner!
• NOTICE:
Install the wall duct with a slope of 1 – 2° to the exterior wall in order to ensure that
occuring condensate may drain away.
• NOTICE:
In order to prevent algae accumulation and a discolouration of the façade around
the weather protection hood observe all installation advices (apply all sealing tapesl!). In
vulnerable areas, apply a biocidal/water repellant treatment to the plaster surface around the
weather protection hood before installing. Consult your planner!
• If your device has a defect, contact your nearest distributor or our technical service.
Any kind of use other than the intended use will exclude all liability claims.
