Fig. 8
Fig. 9
Fig. 11
Fig. 10
Fig. 12
STARTENT ASSEMBLY INSTRUCTIONS
12
STARTENT
ASSEMBLY
INSTRUCTIONS
14. Fasten the corners of the tent to the anchors with loosened up to
the maximum tensioning straps.
15.
Put the pole together by sliding one element into the other (Fig. 9).
16. After placing the pole crown, screw it with the black knob through
an eyelet attached to the top of the roof (Fig.10).
17. Depending on the type and hardness of the substrate, adjust the
length the anchor pin by screwing it in (Fig.11).
18.
Attach to the base the handle for lifting the pole (Fig.12).
19.
Place the pole holding the handle and pole tube. After placing
check that the pole is vertical (Fig. 12).
20. Start stretching the fabrics using the tension straps with buckles.
Be sure to tighten the straps on the opposite sides and not in a row.
21. Sidewalls can be attached only before the canopy is completely
stretched. After attaching sidewalls, fasten metal rings at the bottom
corner with metal D-rings fastened to try square anchors. It prevents
zip fasteners of the sidewalls from tearing.
ASSEMBLING OF A STEEL POLE
(STARTENT NORMAL AND BIG)
