www.inventini.com
EN
15
DISASSEMBLING OF STEEL POLE
(STARTENT NORMAL AND BIG)
1. Release the tension straps but do not unfasten them completely.
For a multi-pole tent, repeat this step for each pole.
2. Perform the rest of operations in reverse order to the assembly
instructions.
3. Unfasten carabiners from the canopy to prevent fabric damage.
DISASSEMBLING OF INFLATABLE POLE
(STARTENT PASCAL NORMAL AND BIG)
1. Unblock the pump valve pressing it tightly and blocking the central
pin of the valve in the OPEN position. To do this, press it and turn
about 10 degrees right or left. To remove the air from the pole,
you can:
• use the pump in ‚pump out’ mode (connect the pumping hose to
the opposite side of the pump). When you remove the air from the
pole using a pump, there is no need to block the valve in the open
position as the pump does it automatically. Anyway, by doing it
you will fasten the process of removing the air.
• do it manually by blocking the pump valve in the OPEN position
(press it). While pumping out unfasten the carabiner fromm the
canopy, then fold the pole starting from the tip towards the base.
Repeat the steps for each pole if you disassemble a tent with 2 or
more poles.
2. Perform the rest of operations in reverse order to the assembly
instructions.
3.
Unfasten carabiners from the canopy to prevent fabric damage.
FOLDING THE CANOPY
Hold the tip, then fold the corners of the tent together (start folding
from its tip). Fold the canopy to form a strip not wider than the width
of a transport bag. Roll the canopy tight from the tip towards the
corners.
STARTENT
DISASSEMBLY
INSTRUCTIONS
