SAFETY AND OPERATING MANUAL
21
202093 ROTARY HAMMER 1500W
5. OPERATING INSTRUCTIONS
1. INSERTING AND REMOVING DRILL BIT (See Fig. A)
INSERTING
Clean the bit shank and apply grease before installing the
bit.Hold the rotary grip, pull back the locking sleeve and
insert the bits into the bit holder.Turn the bit and push it in
until a resistance is felt, the shaft drops completely into
bit holder.Once you are satisfied it has seated, release
the black locking sleeve.This should lock the bits into
position.
After installing always make sure that the tool is securely
held in bit holder by trying to pull it out.
If the bit is not located well, repeat the installation opera-
tion again.
REMOVING
To remove the bit, pull back the locking sleeve, hold and
pull the bit out.
2. ADJUSTING THE AUXILIARY HANDLE (See Fig. B)
For your personal safety we recommend using the
auxiliary handle at all times.
To adjust the handle, rotate the bottom of the handle
anti-clockwise and rotate the handle around the
hammer collar until the handle is in the desired position.
Tighten fully.
3. ON/OFF SWITCH (See Fig. C)
Depress the On/Off switch to start and release it to
stop your tool.
Summary of Contents for 202093
