SAFETY AND OPERATING MANUAL
20
202106 280W DELTA SANDER
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a hazardous
situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease.
Slippery
handles and grasping surfaces do not allow for safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
Note:
Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for dry sanding–with high
removal capacity–of wood, plastic, metal, filler as well as
varnished surfaces.
1. FITTING THE SANDING PAPER (See Fig. A)
The sanding paper and base plate are provided with a
hook and loop attachment system to allow quick and
easy changing of the sanding and polishing accessories.
Remove any dust or other objects from the hook and
loop on the base plate and sanding paper. Position the
sanding paper evenly on the base plate and firmly press
down to attach them together. You must align these with
the holes in the base plate in case the sanding paper
blocks the dust extraction. To remove the sanding paper,
lift one corner of the paper and pull it off from the base
plate.
2. SWITCHING ON AND OFF (See Fig. B1, B2)
To start the machine, push the on/off switch forward so
that the “I” is indicated on the switch.
To switch off the machine, push the on/off switch toward
the rear so that the “0” is indicated on the switch.
4. OPERATING INSTRUCTIONS
A
Pull
Stick
B1
B2