EN - 8
9. HANDLING AND TRANSPORTATION
Whenever the machine is to be handled, raised, transported
or tilted you must:
• Stop the machine (par.6.5) until the moving parts come to a
complete halt.
• Remove the spark plug cap (Fig.23.B) or remove the key
(Fig.23.D) or the battery (for models with push-button elec-
tric start command).
• Wear heavy work gloves.
•
Holdthemachineinthepointsofferingasafegrip,taking
into account the weight and its division.
• Use an appropriate number of people for the weight of the
machine and the characteristics of the vehicle or the place
where it must be placed or collected.
• Make sure that machine movements do not cause damage
or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and length.
•
Loadthemachinewiththemotorswitchedoffandpushedby
an adequate number of people.
• Lower the cutting means assembly (par 5.5).
• Position it so that it cannot cause a hazard for anybody.
•
Fastenfirmlytothedeviceoftransportusingropesorchains
to prevent it from tipping over causing damage and fuel
leaks.
Do not transport machines that can be stored in
vertically in such an upright position.
10. MAINTENANCE TABLE
Intervention
Frequency
Notes
MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear/lateral discharge
guards; Check the grass catcher bag and lateral discharge chute; Check the cutting
means.
Before use
par. 6.2.2
General cleaning and inspection; Checking for any damage to the machine.
If necessary, contact the authorised service centre.
After each use
par. 7.4
Replacing the cutting means
-
par. 7.3.1 ***
ENGINE
Checking/topping up fuel level; Check/top-up engine oil
Before use
par. 6.1.1 / 7.2.1 * / 7.2.2 *
Airfiltercheckandcleaning
; Spark plug contacts check and cleaning;
Spark plug replacement; Charging the battery
*
* / par. 7.5 *
*Refertotheenginemanual.***Operationtobeperformedatthefirstsignsofanymalfunction
*** The operation must be carried out by your Dealer or a Authorised Service Centre
Summary of Contents for CP1 434 K
