16
Connection between transmitter and receiver
Step 1
Push the LiPo battery into the battery
compartment of the quadcopter as
illustrated. The blue LEDs on the quad-
copter will start flashing. Now place the
quadcopter on a level surface.
Step 2
Move the ON/OFF switch on the remote
controller to ON (with throttle stick in
lowest position). Now move the throttle
stick quickly from the lowest position
to full throttle and back to the lowest
position to start the connection between
transmitter and receiver. The blue LEDs
now glow constantly.
Caution:
Do not allow the Quadcopter to
move until the blue LEDs shine constantly
(not blinking).
Step 3
Remove the LiPo battery from the
quadcopter after flight.
Never leave LIPo battries in the model
for a longer period of time as this can
lead to deep discharges or even fire.
Step 4
Switch of the controller after flight.
Remove the batteries for storage if the
controller is not to be used for a longer
period of time and prevent battery
leakage, controller damage or even fire.
LiPo battery
3.7 V 250 mAh
LiPO battery
3.7 V 250 mAh
ON/OFF switch
ON/OFF
Push the throttle stick to the lowest position.
