before using for the first time
3
Follow these instructions when using the appliance for the first time: Carefully unpack the air conditioner and all accessories
and remove all packaging material and any promotional stickers.
Keep the packaging (plastic bags and cardboard) out of reach of children.
After unpacking the appliance, carefully check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient ventilation.
Check that all mentioned accessories have been supplied.
Clean the air conditioner with a slightly damp cloth.
Prior to connecting the appliance, check that:
• the connection voltage corresponds with what is stated on the information plate;
• the socket and cord are suitable for the appliance;
• the plug of the cord fits in the socket;
• the appliance is placed on a stable and flat surface.
PLACEMENT OF THE AIR CONDITIONER
• The appliance should be placed on a sturdy, flat surface with sufficient
free space around it.
• Do not block the air outlet and ensure a free space of minimum 45 cm
around the appliance.
• After placing the appliance in a straight position, allow it to stand for at least
2 hours before inserting the plug in the socket.
• For the benefit of easy movement, the appliance has been provided with castors.
Carefully roll the appliance over the floor. Make sure the floor is flat and try not to drive
over anything.
•
REMARK:
Optimum operation of the appliance depends on the length of the discharge
hose and the number of bends. Try to limit both. The supplied flexible discharge
hose has a maximum length of approx. 150 cm and corresponds with the capacity
of the appliance. The use of any other hoses or extensions could cause failures in the
appliance. The air should be able to flow without hindrance, or else this could lead
to overheating of the appliance or condensation of water in the air discharge hose.
Therefore make sure there are no kinks or sharp bends in the discharge hose.
For an optimum result, the discharge hose should be kept shorter than 1 metre
during use of the appliance.
INSTALLING THE AIR DISCHARGE HOSE
Place the appliance near a window or opening, so that the air can flow to the outside
via the discharge hose.
1.
Carefully pull out the discharge hose until the required length is achieved.
2.
Screw the connection piece on one end of the discharge hose.
3.
Screw the other connection piece on the other end of the discharge hose.
4.
Attach the discharge hose to the air outlet on the rear of the appliance.
5.
Hang the other end of the discharge hose to the outside. Ensure a free passage of the hose. Close the window or door
to the extent possible. If necessary, use the window seal set.
Fig. 1
Fig. 2
Fig. 3
1. slide on
2. screw tight
English
•
39
Summary of Contents for AC125W
Page 2: ...2 ...
