Caution:
• Condensation water may run out of the drain when the screw cap
is removed and the appliance has been used in cooling mode.
Keep a drip tray at hand when removing the screw cap, in order
to collect the condensation water.
• Make sure the discharge hose for the condensation water properly
descends and is not higher than the drain of the appliance.
• When using the cooling position, it is recommended to not
discharge the condensation water continuously, but to close
the screw cap again. In this way the appliance is able to provide
its best performance.
AIR CIRCULATION
When using this position, the air discharge hose does not have to be connected.
• Press the [ mode /
] key until the indicator light - air circulation - lights up.
• Press the [ speed /
] key to set the wind speed to - high
, medium or low -.
This is indicated on the display as follows:
high speed,
medium speed,
low speed.
AUTOMATIC POSITION
When using the automatic position, the appliance automatically selects whether it should cool or circulate air. This depends
on the room temperature.
• Press the [ mode /
] key until the indicator light - auto - lights up. The display shows the following:
• It is possible to adjust the wind speed. Press the [ speed /
] key to select the required wind speed.
When the room temperature is below 23°C, the appliance starts to circulate the air, and above 23°C the appliance starts to cool.
ADJUSTING THE TIMER -
The timer function can be used to allow the appliance to switch on automatically (delayed start) or switch off automatically
at a set time (automatic deactivation).
Delayed start
• Switch on the appliance and select the position you want to use.
• Switch off the appliance. The appliance remembers the last setting and will switch on at that position/temperature.
• Press the timer key
when the appliance is off and the screen will display 1-24 hours.
• Press the timer key
several times until the desired time is displayed. Wait 5 seconds until the timer is confirmed. The
indicator light of the timer lights up and the timer symbol is shown in the display.
• When the set number of hours have passed, the appliance switches on automatically.
To cancel the delayed start, press the timer key
once more or press the ON/OFF key .
Automatic deactivation
• Press the timer key
when the appliance is on. The display will show hours.
• Press the timer key
several times until the desired time is displayed. Wait 5 seconds until the timer is confirmed. The
indicator light of the timer lights up and the timer symbol is shown in the display.
• When the set number of hours have passed, the appliance switches off automatically.
To cancel the automatic deactivation, press the timer key
once more or press the ON/OFF key .
42
•
English
Summary of Contents for AC125W
Page 2: ...2 ...
