appliance description
2
before the first use
3
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the appliance after unpacking for any
damage, possible from transportation. Place the appliance on a flat and stable surface.
This appliance should be installed and connected to the power supply by a recognized fitter who is familiar with, and works according
to the correct safety regulations.
How to install the appliance, is instructed in the installation instructions (chapter 7).
The appliance must be connected with a properly installed fused socket. The power supply (AC) and voltage at the operating point
must correspond with the details on the rating label of the appliance.
EXTRACTION SYSTEM
This cooker hood can be connected in two ways: to a duct or as a recirculation hood. Install the cooker hood according to the
instructions depending on your choice.
VENT OUTSIDE - to a duct, the cooking vapours extracted by suction are carried
outside, once the grease particles have been filtered. This is the best method.
RECIRCULATE - as a recirculation hood, the grease particles and the smell in the
extracted vapours are filtered. The air that has been sucked in is not carried outside
but recirculates in the kitchen. In this case you must have a carbon filter fitted.
Attention!
The starter kit for recirculation en the carbon filters are not included. You need to
order these separately. Order the accessories at your supplier or at the Inventum spare parts
webshop.
STARTER KIT for recirculation - article number SB900
3 CARBON FILTERS for model AKB9004ARVS - article number KB93
20
•
English
2
1
3
4
5
6
1.
Inner chimney
2. Outer chimney
3. Cooker hood
4. Controls with backlight
5. Metal grease filters - 3
6. Lighting (LED strips 2 x 2.1W)
