controls
4
cleaning & maintenance
5
Before performing any maintenance operation, disconnect the cooker hood from the mains power supply. Ensure that it is
switched off and pull the plug or remove the connector fuse.
Clean the in- and outside of the cooker hood regularly. Clean the cooker hood with warm soapy water and a soft cloth. If your model
is stainless steel, clean it with a stainless steel care product. Do not use any abrasive cleaning agents such as powder cleaners or
cleaners that contain alcohol. Clean the controls only with a damp cloth.
Attention:
failure to carry out the basic cleaning recommendations can cause fire risks.
GREASE FILTERS
A metal grease filter filters the fat particles in the air. Therefore the filter can get clogged, depending on the use. The metal grease filter
does not have to be replaced, but should at least be cleaned once a month. You can clean it either by hand or in the dishwasher on a
low temperature. Make sure the grease filters are competely dry before placing them back.
Do not use any abrasive cleaning agents.
Not cleaning the grease filters on time can cause fire risks.
Cleaning the grease filters in the dishwasher can cause discoloration. This has no effect on the operation.
REMOVING THE GREASE FILTER
Switch off the electricity! Remove the plug from the socket.
Pull the grease filter towards you and tilt it downwards at the front. Make sure
you guide the grease filter with you other hand to prevent the grease filter from
falling down on your cooking appliance.
English
•
21
SWITCHING THE COOKER HOOD ON AND OFF
To select the functions of the cooker hood, press the control buttons gently.
1 OFF/ SPEED DECREASE-
Press the button
-
to switch the engine off or to decrease the speed of the engine.
2 ON/SPEED INCREASE -
Press the button
+
and the engine is on at the lowest setting - 1.
Press the button
+
again and the engine is set to the middle setting - 2.
Press a third time on the button
+
and the engine is set to the highest setting - 3.
3 DISPLAY -
shows the setting of the engine speed and the setting of the timer.
4 TIMER -
by setting the timer the cooker hood will automatically switch off after the set time. The timer can be set with a minimum
of 10 minutes to a maximum of 90 minutes - in increments of 10 minutes.
• Switch the cooker hood on at setting 1, 2 or 3.
• Press the button to set the timer. The display shows a blinking 0. Select with the button
+
the desired switch off time.
Keep in mind that the number on the display stands for 10 minutes. 1 = 10 minutes; 2 = 20 minutes; 3 = 30 minutes; 4 = 40
minutes; 5 = 50 minutes; 6 = 60 minutes; 7 = 70 minutes; 8 = 80 minutes; 9 = 90 minutes.
• Confirm the selected switch off time by pressing the button again. The display now shows the set engine speed, setting 1, 2 or
3 with a blinking dot. The blinking dot shows the timer is counting down.
• The timer can be switch off by pressing the key again while the timer is counting down.
Caution:
the setting of the timer must be completed within 20 seconds, otherwise no action will be taken, and the cooker hood will
resume operation in normal mode.
5 LIGHTING -
Press the key
to switch on the lighting. Press the same button again to turn off the lighting.
Switch the lighting on if you need more light on your cooking appliance. It is recommended to operate the appliance a few minutes
prior to cooking. Leave the appliance in operation for 10 minutes after the cooking is finished to remove all the smells from the kitchen.
1
2
3
4
5
