appliance description
2
before the first use
3
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the
packaging material. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the appliance
after unpacking for any damage, possible from transportation. Place the appliance on a flat and stable surface.
This appliance should be installed and connected to the power supply by a recognized fitter who is familiar with, and works
according to the correct safety regulations.
How to install the appliance, is instructed in the installation instructions (chapter 7).
The appliance must be connected with a properly installed fused socket. The power supply and voltage at the operating
point must correspond with the details on the rating label of the appliance.
EXTRACTION SYSTEM
This cooker hood can be connected in two ways: to a duct or as a recirculation hood. Install the cooker hood according to
the instructions, depending on your choice.
VENT OUTSIDE - to a duct, the cooking vapours extracted by suction are
carried outside, once the grease particles have been filtered.
RECIRCULATE - as a recirculation hood, the grease particles and the smell
in the extracted vapours are filtered. The air that is sucked in is not carried
outside, but recirculates in the kitchen. A good out flow of the air is necessary.
Extra information:
• Note: new houses may no longer vent outside.
• For recirculation, it is necessary to use carbon filters or a plasma filter. For more
information on the differences between carbon and plasma filters check the website
www.inventum.eu.
Attention!
The starter kit for recirculation, carbon filters and plasma filter are not
included. You need to order these separately.
1.
Inner shaft
2. Outer shaft
3. Cooker hood
4. Controls
5. Metal grease filters - 3
6. Lighting (LED spots 2 x 2.0W)
18
•
English
2
1
3
4
5
6
