inventum GV010, Instruction Manual

9

In the event of a problem, you should:

•  switch off all working units of the cooker;

•  disconnect the mains plug;

•  call the service centre;

•  some minor faults can be fixed by referring to the instructions given in the table below. Before calling the customer support centre

check the following points that are presented in the table.

Problem

Reason

Action

A burner does not light

Flame openings are soiled

Close the gas with cutting off valve, close 

burner knobs, air the room, take out and clean 

the burner, blow on the flame openings. 

A gas ignitor does not light

Break in the power supply

Check the household fuse box; if there is a 

blown fuse, replace it with a new one. 

Break in the gas supply

Open the gas supply valve.

Soiled (greasy) gas ignitor

Clean the gas ignitor.

Control knob of the burner not 

pressed in long enough

Hold the control knob pressed in until a full 

flame appears around the burner crown.

The flame goes out when lighting a 

burner

Control knob of the burner 

released too quickly

Hold the control knob down longer at the 

"large flame" position. 

The electrical functions do not work

Break in the power supply

Check the household fuse box, if there is a 

blown fuse, replace it with a new one. 

The oven lighting does not work

The bulb is loose or damaged

Tighten up or replace the blown bulb (see the 

chapter Cleaning and Maintenance).

problems and solutions

The appliance was configured for the appliance category K (I2K) and is suitable for the use of G and G+ distribution gases according 

to the specifications as included in the NTA 8837:2012 Annex D with a Wobbe index of 43.46 – 45.3 MJ/m3 (dry, 0 °C, upper value) or 

41.23 – 42.98 (dry, 15 °C, upper value). 

This appliance can moreover be converted and/or be calibrated for the appliance category E (I2E).

This therefore implies that the appliance: “is suitable for G+ gas and H gas or is demonstrably suitable for G+ gas and can 

demonstrably be made suitable for H gas” within the meaning of the “Dutch Decree of 10 May 2016 regarding amendment of the 

Dutch Gas Appliances Decree….”

English 

•

37

REGULAR INSPECTIONS

Besides keeping the cooker clean, you should also:

•  carry out periodic inspections of the control elements and cooking units of the cooker. After the guarantee has expired you should 

have a technical inspection of the cooker carried out at a service centre at least once every two years,;

•  fix any operational faults

•  carry out periodical maintenance of the cooking units of the cooker.

Caution! 

All repairs and regulatory activities should be carried out by the appropriate service center or by an appropriately authorised fitter.