appliance description
2
1.
Temperature knob
2. Lid
3. Water reservoir
4. Base unit
5. Bottom
6. Drip tray
7. Cup grille
8. Water outlet
9. On/off button
10. Reset button (behind the water reservoir)
11. Rubber cap for water drain (bottom side)
before using for the first time
3
Follow these instructions when using the hot water dispenser for the first time: Carefully unpack the hot water dispenser and all
accessories and remove all packaging and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach
of children. After unpacking the machine, check it for external damage that may have occurred during transport. Place the hot water
dispenser on a heat-resistant flat surface.
The minimum water filling volume is 0.5 litres. The maximum filling volume is 2.2 litres.
Clean the water reservoir and rinse it thoroughly. Rinse the appliance two times, prior to use.
• Place a large mug or bowl under the water outlet.
• Fill the water reservoir to its maximum level and switch the appliance
on
.
• Caution:
switch
off
the appliance when the mug or bowl is full. Empty the
full mug in the sink and place it back under the water outlet.
• Switch the appliance on again.
• Repeat these steps until the appliance has been rinsed with a full water
reservoir twice.
• The appliance is now ready for use.
The hot water dispenser is only suitable for boiling water. Never fill the hot water dispenser with milk, tea, coffee or other liquids.
Placing the anti-scale filter
Open the lid of the water reservoir and place the filter bucket. It will fit in the water reservoir in only one way.
Place the filter in the opening of the filter bucket and close the lid of the water reservoir.
9
1
2
3
4
5
8
7
6
off
on
English
•
11
Summary of Contents for HWD722
Page 2: ...2...
