installation instructions
13
• The safety during use can only be guaranteed when the hob is installed correctly and according to the regulations. The installer is
responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local regulations the
installation must comply with.
• The appliance falls under protection class III and can only be used in combination with a grounding conductor connection. The
manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical installations.
• The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation must be
installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. It must be positioned so that it
does not touch any of the hot parts of the oven.
• The connection point, the wall socket and/or plug must always be accessible.
• The cabinet into which the oven is fitted, must be heat resistant (> 75°C).
• Ensure that the cabinet into which the oven is installed is secure. For example, by mounting it to the adjoining elements.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
Attention:
any change to the appliance’s interior, including fitting and changing the power cable, must only be performed by a
qualified electricien.
problems & solutions
12
Problem
Solution
The touch keys don’t respond.
Unplug the appliance or remove the fuse in the fusebox. Wait a
few minutes before plugging the appliance back in.
The oven lamp is not lit.
Replace the oven lamp according to the instructions.
The oven is not heating up.
- Has the correct temperature and oven function been set?
- Is the door of the oven closed properly?
The display of the clock is
flashing.
- There has been a power failure. Reset the clock.
- The oven is switched off because the set cooking time and/
or end of the cooking time has passed. Press the central key
CLOCK to end the function and reset the knobs.
The control light of the oven
function is not lit up.
- Is an oven function selected?
- Is the beginning of the cooking time delayed? The oven will not
start until it reaches the set time.
English
•
25
IOV6011-instructions.indd 25
15-12-2014 12:14:27
