inventum MX301S, Instruction Manual

The 

TURBO

 button can also be used for instant power pulses 

without having to set the speed.

Attention: 

do not activate the stick mixer constantly, this can 

cause engine problems. Do not use the stick mixer for more 

then one minute continuously, wait until the engine is cooled 

down in three minutes before operating it again. Blend larger 

quantities in multiples sessions.

The stick mixer can’t exceed a running time of 15 seconds 

without a load.

Always unplug the appliance from the supply if it is left 

unattended and before assembling, disassembling and during 

cleaning. 

You can use the stick mixer in the measuring cup and also 

in another bowl. When blending directly in a saucepan while 

cooking, take the pan from the stove first to protect the 

appliance from overheating.

The anti-slip base is also an airtight lid for the measuring cup.

using the whisk

5

Use the whisk for example for making whipped cream or beating 

egg whites.

•  Take the motor part, the connector and the 

whisk. 

•  Attach the connector to the whisk.

•  Attach the whisk to the motor part by turning 

the connector clockwise. 

•  Check whether the speed control is set on the 

lowest speed - to the right. You will get the best 

result.

•  Plug in the appliance. 

•  Place the ingredients in the measuring cup. 

Make sure the measuring cup is not too full.

•  Place the whisk in the measuring cup.

•  Press the 

ON

 button to use the speed setting 

you have set on top of the motor part.

•  As soon as you release the button (on or turbo), 

the whisk will stop.

Always  unplug the appliance from the supply 

if it is left unattended and before assembling, 

disassembling and during cleaning.

To remove the whisk after use, turn it anti 

clockwise from the motor part and pull the whisk 

from the connector.

using the chopper

6

Warning: the blades of the chopper are extremely 

sharp. Be careful while assembling, emptying the 

chopper bowl and cleaning.

The chopper is suited for chopping meat, cheese, onions, herbs, 

garlic, carrots, nuts, etc.  

Attention:

 do not chop any hard ingredients such as ice cubes.

•  Place the chopper bowl on a flat surface.  

•  Place the knife on the axle in the centre of the bowl. 

Pay 

attention - the knives are extremely sharp.

•  Place the ingredients in the bowl.

•  Place the lid. 

•  Take the motor part and attach it by turning it clockwise onto 

the lid of the chopper. 

•  Check whether the speed control is set on the lowest speed - 

to the right.

•  Plug in the appliance. 

•  Press the 

TURBO

 button for maximum speed or press the 

ON

 button to use the speed setting you can set on top of the 

motor part.

•  During processing, hold the motor part with one hand and the 

chopper bowl with the other hand. 

Attention:

 do not activate the chopper constantly, this can 

cause engine problems. Do not use the chopper for more 

then one minute continuously, wait two minutes before you 

operate it again. 

•  As soon as you release the button (on or turbo), the chopper 

will stop. Wait until the knife stops rotating before you take 

the lid of.

The

 TURBO

 button can also be used for instant power pulses 

without having to set the speed.

Always unplug the appliance from the supply if it is left 

unattended and before assembling, disassembling and during 

cleaning. 

To remove the motor part after use, turn it anti clockwise from 

the lid.

The anti-slip base is also an airtight lid for the chopper.

12

•

 English