BALNAFETTACH HOUSE, PH26 3LW (01479) 872 518 ADMIN@INVENTYS.CO.UK
MicroFogger 3 Pro -
User Manual
(V22.1 Jan22)
Initial Preparation
–
IMPORTANT Please Read!
Turn MF3
“ON” using the
black rocker switch BEFORE attaching the charging cable,
Put the included USB charging cable into a USB charger socket outlet and Then connect
USB charging cable to the MF3.
Only use a wall socket/mains supplied type of USB charger to ensure the unit charges fully
and also to prevent unintentional activation during charging.
Allow the MicroFogger to fully charge before beginning to use it. This can take up to 6 hours.
•
NOTE
: The MF3 Lite will only accept charge if it has been turned on as described above.
•
Carefully unscrew the black fluid tank (see image bottom right) by turning anti-clockwise
•
Double check that a coil is installed (it usually is)
•
Using the 50ml bottle of fog liquid, unscrew bottle cap. Using the pipette-style tip,
carefully pour fog liquid into the
gap
between the inner and outer walls of the reservoir.
DON’T
pour into the central part (coloured RED in image)
. D
on’t
squeeze the bottle too
hard
–
or you’ll overfill and spill the liquid
!
•
Keep filling the fluid tank until the liquid is at the
same level as the top of the interior metal wall.
•
At this stage
–
with fingers
–
check the coil (small
silver cylinder) is firmly screwed into place (good
finger tight!)
•
Holding the reservoir tank upright,
invert
the MF3 body on to
it and screw the body on to the tank (again,
good finger tight
).
Turn the MF3 back to the upright position.
•
Now make a cup of tea/coffee as you should
let the MF3 Lite
rest upright for a minimum of 30 mins
(this ensures that the
liquid properly seeps into the new heating coil). The coil may
be damaged if you don’t wait the 30 mins
.
