BALNAFETTACH HOUSE, PH26 3LW (01479) 872 518 ADMIN@INVENTYS.CO.UK
How long does the smoke linger in the air?
Depending on atmospheric conditions, the smoke can remain in the air for up to an hour
after being released. The main factor affecting persistence is whether or not there is any air
movement, drafts as these will greatly accelerate smoke dispersion.
Do original MicroFogger heating coils work with the MicroFogger 3?
Absolutely, we’ve kept the heating coils the same so that you can use any that
you have
previously purchased from us.
What obstacles can the remote control signal go through?
It really depends on the exact situation but in general, as a rough guideline, you will be able
to control the MicroFogger though several thin plaster walls. Similarly, if you decide to put it
into cardboard or fabric enclosure, you sh
ouldn’t encounter any issues. On the other hand,
metal barrier such as car doors will usually block the signal although we have even had luck
with activating the MicroFogger while it was inside a car hood!
Can I control the MicroFogger 2 via a wired remote?
Yes, the usb charging port also doubles as a signal input which allows you to trigger the
MicroFogger using a switch, relay or micro controller of your choice.
You’ll need our control cable accessory to
access this functionality.
….. And Finally
If you believe that your Microfogger is faulty,
please check the Troubleshooting section
of
this manual.
If your problem persists, please reach out to us at the email address below.
If it is a specific question about your order, please include your Invoice/Order number which
can be found on your printed invoice
.
Spares and replacements available can be viewed on the manufacturer
’
s website here:-
