BALNAFETTACH HOUSE, PH26 3LW (01479) 872 518 ADMIN@INVENTYS.CO.UK
Charge Lock ON/OFF
Sets whether the MicroFogger can be activated via the control cable while it is charging.
Keep this setting
“
off
”
at all times unless you are both charging and triggering the
MicroFogger simultaneously.
Turning it on may result in unintentional activation while charging.
Screen DIM/BRIGHT
Changes the brightness of the display screen.
Info Screen
Displays the software version number.
Normal Operation
•
Holding down the large round
“
Trigger
”
button while the MicroFogger is turned on will
begin smoke production.
•
To maximize heating coil lifespan, we recommend a 10 second limit on continuous use
after which point, it is advisable to wait at least another 10 seconds before the next
burst to allow the fog fluid to be re-absorbed. Failure to do so will cause excessive coil
wear and may make the smoke smell burnt. If you observe this, follow the instructions
in the “storage and maintenance” section of this manual to replace
the heating coil.
In extreme cases, if you keep running the MicroFogger even after the heating coil has
worn out, small burning fragments of the absorbent material may be ejected out of the
nozzle.
•
Although the MicroFogger can be used in any orientation provided that the tank is
mostly full, we still recommend that you keep it upright (with the nozzle pointing
vertically upwards) as much as possible.
This position allows the coil to optimally absorb the liquid, even if the tank is near-
empty.
If there isn’t much fog liquid remaining in the tank, avoid using the MicroFogger in any
orientation other than upwards as this would have the same effect as running it without
any liquid.
•
If you are mounting the MicroFogger in a static position and require smoke output in a
downward direction, we would recommend using our optional hose attachment or Loc-
Line accessories.
•
After each use, we recommend ejecting any excess fog liquid that may have re-
condensed within the barrel of the MicroFogger.
