21
NOTE:
To create sufficient clearance between Footrests when the seat width is set
to 300mm, outrigged Footrest Hanger Mounts are used, Figs.17a & 17b.
Footrest Height adjustment:
This procedure can normally be carried out with
the User seated.
Tool Required: 4mm Hexagon Key.
Slacken grub-screw (
a
) Fig.18.
Adjust Footrest to height by sliding the
Footrest Stem upwards or downwards, within
the Hanger to the required position.
Re-tighten grub-screw sufficiently to prevent
movement.
NOTE:
Ensure there is at least 40mm of Footrest
Stem inside the Hangers before tightening grub-
screws.
Footrest Angle adjustment:
This procedure can normally be carried out with
the User seated.
Tool Required: 4mm Hexagon Key.
Slacken locking screw (
b
) Fig.19.
Adjust Footrest angle, by revolving the
Footrest around its pivot to the required
position.
Re-tighten locking screw sufficiently to prevent
movement.
Fig. 18
(
a
)
Footrest Stem
Fig. 19
(
b
)
Fig. 17b
Hanger Mounts
350 & 400mm
Seat Widths
300mm
Seat Width
Summary of Contents for IPC-S
