Goodrive18 series two-in-one VFD Function parameters and function terminal reuse
-64-
Function
code
Name
Description
Default
value
Modify
displayed when you press the PRG/ESC key
again to enter the function code editing interface.
You need to enter the correct user password to
enter the interface.
Note:
Exercise caution before restoring the
function code to the default value, which will
clear the user password.
P07.01
Parameter
copying
0: No operation
1: Upload local function parameters to the
keypad
2: Download keypad function parameters to a
local address (including motor parameters)
3: Download keypad function parameters to a
local address (excluding the motor parameters of
P02 and P12)
4: Download keypad function parameters to a
local address (only including the motor
parameters of P02 and P12)
Note
: After any of operation options 1
–4 is
performed, the parameter is restored to 0, and
the upload and download functions are not
applicant to P29. This function is only applicable
to the external keypad with parameter copying.
0
◎
P07.02
Key function
selection
0x00
–0x27
Ones: QUICK/JOG key function
0: None
1: Jogging
2: Shifting-key switchover display status
3: Switchover between FWD/REV rotations
4: Clear UP/DOWN setting
5: Coast to stop
6: Switch running-command giving modes in
sequence
7: Quick commission mode (based on non
factory parameters)
Tens:
0: Not lock keys
0x01
◎
Summary of Contents for GD18-004-4-2
Page 1: ......
