Goodrive350 series high-performance multifunction VFD
Basic operation guidelines
-37-
GD350
16:02:35
Fwd
Local
Ready
Set Freq
P17.00 Hz
50.00
DC Bus Volt
P17.11 V
540.0
000000
About
Parameter
Menu
HDIB/A/S4/3/2/1
P17.12
A
B
C
D
E
F
Figure 5-2 Main interface of LCD
Area
Name
Used to
Header A
Real-time display
area
Display the real-time; clock battery is not included; the time
needs to be reset when powering on the VFD
Header B
VFD running state
display area
Display the running state of the VFD:
1.
Display motor rotating direction: "Fwd"
– Run forward
during operation; Rev
– Run reversely during operation;
"Disrev"
– Reverse running is forbidden;
2.
Display VFD running command channel: "Local"
–
Keypad; "Trml"
– Terminal; "Remote" - Communication
3.
Display current running state of the VFD : "Ready"
–
The VFD is in stop state (no fault); "Run"
– The VFD is in
running state; "Jog"
– The VFD is in jogging state; "Pre-alarm"
– the VFD is under pre-alarm state during running; "Fault" –
VFD fault occurred.
Header C
VFD model display
area
VFD model display: "GD350"
– current VFD is GD350 series
VFD
Display D
Parameter names
and function codes
on the VFD
homepage
Display a maximum of three parameter names and function
codes on the homepage. The parameters diplayed on the
homepage can be managed.
Display E
Values of parameters
on the VFD
homepage
Display the values of parameters on the VFD homepage,
which are updated in real time.
Footer F
Corresponding
menus of function
keys (4), (5) and (6)
Indicate the menus corresponding to function keys (4), (5)
and (6). The corresponding menus of function keys (4), (5)
and (6) vary with interfaces, and the content displayed in this
area varies also.
5.3 Keypad display
The VFD keypad can display the stopped-state parameters, running-state parameters, function
parameter editing status, and fault alarm status.
5.3.1 Displaying stopped-state parameters
When the VFD is in stopped state, the keypad displays stopped-state parameters, and this interface
