Lighting Control
1.
The lighting effects are controlled by LED switch. If your motherboard supports ARGB
headers, simply hold the button for 3 seconds until the front display flashes to a white light,
then the lighting effects can be controlled by the motherboard software. However, if you
press the LED button again, it will switch back to the InWin LED mode.
2.
When switching from ARGB to the InWin LED
mode, it also can change to different LED
lighting effects by a quick press of the button,
the button sequence is as follows:
Button Presses
LED Modes
Color
1
Monochromatic
Red
2
Green
3
Blue
4
Purple
5
White
*
6
Breathing
Red
7
Green
8
Blue
9
Purple
10
White
*
11
Monochromatic
Scrolling
Red
12
Green
13
Blue
14
Purple
15
White
*
16
Gradient Color
Multicolor
17
Multicolor Scrolling
Multicolor
Note* The white featured in the InWin LED mode will be displayed as RGB white instead of pure white.
3. The operation will be considered complete and saved if there is no activity for over 5 seconds. If you
want to change the light effects again, please hold the button for 3 seconds and then return to the
InWin LED mode in order to switch to other light effects.
4. To turn off the lights directly, just hold the button for 5 seconds.
Note* The current settings of lighting effect will be saved if you turn off the computer in the proper way. You can have your
previous lighting settings automatically when reboot the computer. But it will return to factory settings if your
computer is in a power off condition such as: the electricity goes out suddenly, or turning off the power switch before
the computer shutting down.