Installation Guide
If your motherboard does not support an addressable header, please use the
included ARGB One-Click Controller to connect to your PSU’s SATA cable and the
case's ARGB Y-Cable in order to use the 14 different lighting effects.
Bottom ARGB Strip
ARGB One-Click Controller ver. 1.1
Hold the button to turn on or off the lights. Tap the button to change the lighting modes.
Fan 1
ARGB Y-Cable
PSU's SATA cable
1 Rainbow
8 Two-Tone RingRainbow
2 LED-Red Breathing
9 Diagonal Transition
3 LED-Green
10 Rotating LED Trio
4 LED-Blue
11 Full Circle
5 LED-Purple
12 Flow-Red
6 LED-White
13 Flow-Green
7 Light at the end of the Tunnel 14 Flow-Blue
08
Anti-Slip Strips Installation
Parts Require: Anti-Slip Strips
Remove the strip covers and place them under each corner.
