19
2.6
Rail
I
nstallation
The IW-RJ472-05 JBOD is a high density 4U rackmount storage model, which supports
EIA-RS310D standard cabinets and chassis racks. InWin provides standard slide rails for
mounting the JBOD chassis to cabinets.
2.6.1
The Type of Rail Kit
Please follow the instructions to install the rails on the cabinet or chassis rack
according to the rail type you ordered.
2.6.2
Slide Rail
2.6.2.1
Take out the Inner Rail and Slide the Intermediate Rail Back
Step 1: Pull out the inner rail until it reaches the stop. Release the blue
slide tab to unlock.
Step 2: Continue pulling the inner rail until the second stops. Release the
white slide tab to remove the inner rail.
Step 3: Pull the latch on the middle rail upward and retract the middle rail
back.
Step 1
~
2
Step 3
2.6.2.2
Attach the Inner Rail to the Chassis
Step 1: Align the chassis sidewall standoffs to the inner rail keyholes. Slide
the inner rail toward the front until the standoff snaps into place,
securing the rail to the chassis.
Step 2: Repeat the same action on the other side.
Step 3: When removing the inner rail:
Pull up the latch and slide the inner rail forward. Remove the
keyhole from the standoff to detach the inner rail. (Action
and
in the figure)
Step 1
~
3
Summary of Contents for IW-RJ472-05
Page 1: ...IW RJ472 05 User s Manual...
Page 7: ...4 1 Product Introduction 1 1 Box Contents...
Page 21: ...18 Step 2 Step 3 Connects the Cables Connects the Cables...
Page 40: ...37...
