Model : SK-Hybrid BP Series User’s Manual
PAGE 9 OF 16
Hardware Specification
HOST Facing Interface
：
SATA/OCulink
DEVICE Facing Interface
：
SATA/SAS/NVMe
Indicator
：
Indicator
：
Power LED PD1~PD5: Steady Blue –(When HDD is resent)
Dual color(Green/Red) LED D1~D5 for Hard Disk Drive Status (Activity/Failure/Locate)
Activity LED: Blinking Green (When HDD is Access)
Locate LED : Blinking Red (When HDD Fail or Locate)
Fail LED : Steady Red (When HDD Fail or Locate)
Environment Control :
PWM FAN Connector (FAN1) for Cooling system.
Temperature Sensor (RTB1) Monitor HDD bay inside temperature.
M/S Link Connector (JB1) for Synchronous signal connection between two backplane.
Buzzer (SUB1) for Over-temperature and FAN fail alerting.
Connector
SATA-7PIN Connector *1 (SATA1)
SFF-8621 OCULINK 42PIN Connector *2 (NVME1~NVME2)
SFF-8643 MiniSAS HD Connector *1 (CN3)
SFF-8639 U.2 68PIN Connector *1 (DISK1) for SATA Disk or NVMe SSD.
SFF-8639 U.2 68PIN Connector *1 (DISK2) for SATA/SAS3 Disk or NVMe SSD.
SFF-8680 SAS29PIN Connector*3 (DISK3~DISK5) for SATA/SAS3 Disk.
P5.08mm Disk Drive Power Connector*2 (PW1~PW2)
JS1 connector for SGPIO Cable connection from Mother Board to Backplane.
CN1 connector for LED/Mute SW cable connection from Front Panel to Backplane.
JD1 MCU Programming Header for Programming MCU Firmware
S2 DIP Switch for Backplane Master/Slave Selection.
