24
SBV System Series | Instruction manual v1.2 DEC 2021 | SAF-UM-SBVBus-en-v1.2 | © 2021 Inxpect SpA
3. Get to know SBV System Series
Data type
Description
Communication
direction
Safe
TARGET DATA
l
Current distance and angle of the targets detected by each sensor.
For each detection field of each sensor, only the closest target to
the sensor is considered.
from the control
unit
Unsafe
DIAGNOSTIC DATA
ISC-B01 control unit:
l
internal status with an extended description of the error condition
SBV-01 sensor:
l
internal status with an extended description of the error condition
from the control
unit
Unsafe
SYSTEM STATUS AND TARGET DATA
from the control
unit
3.6 Modbus communication
3.6.1 Modbus support
The Modbus communication uses the Ethernet port (Modbus TCP) and consequently is only available for ISC-B01
and ISC-02 control units.
3.6.2 Modbus communication enabling
In the Inxpect Safety application, click on
Settings
>
Modbus Parameters
>
ON
to enable the feature.
Within the Ethernet network, the control unit acts like a server. The client must send requests to the IP address
of the server on the Modbus listening port (default port is 502).
To show and change the address and the port, click on
Settings
>
Network Parameters
and
Settings
>
Modbus
Parameters
.
3.6.3 Data exchanged through Modbus
The following table details the data exchanged through the Modbus communication:
Data type
Description
Communication
direction
Unsafe
SYSTEM STATUS DATA
ISC-B01 or ISC-02 control unit:
l
internal status
l
status of each of the four outputs
l
status of each of the two inputs
SBV-01 sensor:
l
status of each detection field (target detected or not) or error status
l
muting status
from the control
unit
Unsafe
DYNAMIC CONFIGURATION STATUS
l
ID of the dynamic configuration currently active
l
signature (CRC32) of the dynamic configuration ID currently active
from the control
unit
Summary of Contents for SBV System Series
Page 101: ......
