Hydra Super-S3 System Setup
Page 5
2 System Setup
2.1 Hard Drive Assembly
1. Unlock the switch at the bottom of the case and push the inner chassis from the back until the
front panel is out of the housing.
2. Pull the front panel out and then lift it up to remove it.
3. Turn the screws on the cassettes counter-clockwise to loosen and pull them out.
4. Install the hard drive as illustrated below with the SATA connector facing away from the front.
Mount the drive with the six screws from the side.
5. Slide the cassette back into the case, push it lightly into place and fasten the screw.
6. Repeat the previous steps for each hard drive cassette you are planning to install. The drives
can be installed at any position, there is no specific order required.
7. Set the RAID selector switch to your preferred RAID mode and connect the device to your
computer. Press and hold the CONFIRM button, turn on the power, release the button after 5
seconds and replace the front panel. Create a new partition and format the drives.
