ATA2ATAR01
Applications
1234
ON
3
1
4
2
To connect RS-232 and buzzer control extend Cable
RS-232 Setting :
Fan and Temperature fail detector :
RS-232 Port
To Connect Your Computer
You have two way to connect your computer
1. Use RS-232 D-sub 9pin female to D-sub 9pin female
External round Cable
+
- Provides a fan detector and temperature detector and buzzer
driver circuit.
- Provides alarm disable Button/Switch.
Fan Connector
GND 12V CLK
Buzzer
There are three ways to Enable/ Disable the buzzer.
1. Buzzer Control Switch.
2. Buzzer Control Button.
3. EagleEye RAID Manager Utility.
Buzzer Control Switch
BT1:
Buzzer Controle Button
ON: Enable OFF: Disable
Buzzer Control Button
SW1-1:
Buzzer Control
ON: Enable OFF: Disable
Enable/ Disable the buzzer through the EagleEye RAID Manager
Utility
To switch the RAID system Buzzer .
Buzzer
Fan Connector
TX RX
GND
RS-232 Port
Switch 1 "OFF" and connect to Buzzer Button
RS-232 setup
The serial port baud rate is 9600 bps.
When the RAID system window display, click the right top button to
restore window size or display RAID system detail information.
The RAID system detail information include RAID model name, firmware
revision, firmware date, transmission mode, RAID capacity, 1 st and
2 nd hard disk information.
2. Use RS-232 D-sub 9pin female to D-sub 9pin female
External round Cable + USB to Serial (RS-232) Converter
+
