9
Quick Setup
Step 4: Finish Installation
Connect the
Machine Cables
Make sure power is
off to the cutter (the
switch is placed in the
0
position). Connect
the serial or USB cable
and the power cord
to the panel on the
back of the right side
of the cutter. Plug the
machine power cable
into a wall socket or
surge protector.
Connect the
Computer Cable
With power to the
computer off, connect
the serial or USB cable
to one of the ports
on the back of the
computer.
See the In-
stallation chapter of the
SmarTrac User Guide
for more information.
Install the
Software
Insert the installation
CD-ROM into the
computer CD-ROM
drive. The install
program should start
automatically. If it
does not, select
Run
from the
Start Menu
.
Browse to the CD-
ROM and double-click
on
Install Ioline Con-
trol Center
from the
list of options. Press
OK
to start the install.
Install the
Control
Center
software.
Install USB Drivers
Please see the guide labeled
Installing USB Drivers for Ioline Products
on the CD-ROM for the driver installation process.
Figure 12.
Power cable and communication ports.
Figure 13.
Computer communication ports.
Power
Cable
Serial
Port
USB
Port
USB Ports
Serial Port
Figure 14.
The Ioline
Control Center
.
A USB cable is provided in the
Accessory Kit.
Note
i
The Setup program also allows
installation of the electronic User
Guides and the necessary viewer.
Note
i
An adapter (not included) is re-
quired for 25-pin serial connections.
Note
i
