If the problem persists, you can try alternate methods of discovering the StorCenter. See
the OS-specific steps below:
PC Users:
PC Users:
PC Users:
PC Users:
Windows XP/2000:
1. Double click My Network Places
My Network Places
My Network Places
My Network Places
2. Double click Entire Network
Entire Network
Entire Network
Entire Network
3. Double click Microsoft Windows Network
Microsoft Windows Network
Microsoft Windows Network
Microsoft Windows Network
4. Double click Workgroup
Workgroup
Workgroup
Workgroup
Your Iomega StorCenter Network Hard Drive should have the name StorCenter
StorCenter
StorCenter
StorCenter by default.
Windows 98/ME:
1. Double click Network Neighborhood
Network Neighborhood
Network Neighborhood
Network Neighborhood
2. Double click Entire Network
Entire Network
Entire Network
Entire Network
3. Double click Workgroup
Workgroup
Workgroup
Workgroup
Your Iomega StorCenter Network Hard Drive should have the name StorCenter
StorCenter
StorCenter
StorCenter by default.
Mac Users:
Mac Users:
Mac Users:
Mac Users:
OS X, version 10.2.7 or higher:
1. From the Finder menubar, select Go
Go
Go
Go→Network
Network
Network
Network→Workgroup
Workgroup
Workgroup
Workgroup.
Your Iomega StorCenter Network Hard Drive should have the name StorCenter
StorCenter
StorCenter
StorCenter by default.
|
top of page
|
Some Computers on the Network Cannot Connect to the StorCenter
Some Computers on the Network Cannot Connect to the StorCenter
Some Computers on the Network Cannot Connect to the StorCenter
Some Computers on the Network Cannot Connect to the StorCenter
If some of the computers on your network cannot connect to the StorCenter device, your
network may be configured with multiple routers (DHCP & NAT) or with multiple DHCP
servers (some network devices also act as a DHCP device).
If you have more than one router, make sure that the primary router (usually the one
connected to or acting as the DSL/Cable modem) is the only one with DHCP
(Dynamic Host Configuration Protocol) and NAT (Network Address Translation)
enabled. The second or cascaded router should be changed to bridging mode. Make
Page 118 of 137
25-7-2010
http://www.iomega.com/support/manuals/ix-series/221-0809/en/consolidated/printall.h...