Camera Properties:
5
MyoCam-S Hardware Manual
Image Format/Timing Properties - Basic
Basic Image Format/Timing Properties
When Image Format/Timing is selected as the current property AND the Show Advanced Options
check box is NOT CHECKED, the basic version of the image Image Format/Timing controls (shown
above) will be displayed. In basic mode, you enter the desired frame rate and the system will set the
maximum number of lines (y size) and integration time that the camera will support at the given rate.
Values entered in the advanced version of the Format/Timing properties are used in basic
mode. Check Show Advanced Options to see the current values for these 'extra'
parameters.
Frame Information
The Frame Information group displays information about the image. This information is based on
values that can be entered when Show Advanced Options is checked.
Size
Number of pixels and number of lines in each image (frame) acquired
Pixels
Total number of pixels in each image
Bytes
Total number of bytes in each image
Frame Rate
Period
Enter the number 10µs clock periods per frame (i.e. frame period in
milliseconds times 100).
Freq.
Displays the resulting frame frequency for the entered Period given the
current mode (set when Show Advanced Options is checked).
Packet Rate
Displays the USB packet rate. This information is useful for debugging
purposes.
Here are some sample values for Period with resulting Frequencies for progressive mode:
3333=30Hz 1666=60Hz, 1000=100Hz, 500=200Hz, 100=1kHz
Summary of Contents for MyoCam-S
Page 1: ...Hardware Manual MyoCam S ...
