25
• Copying a Pattern to a blank destination Pattern replaces the blank Pattern with the original
Pattern data.
• Copying to a Pattern that already contains data appends the original data to the end of the
data in the destination Pattern. If this would result in a Pattern with more than 128 beats, the
display will say
TOO MANY BEATS
.
• Copying a Pattern to itself doubles the length.
• The Drum Set assignment and Pattern name are copied along with the drum data only if the
destination Pattern is empty.
5.
Press PLAY. The display says
COPY DONE
.
6.
Release the COPY and PLAY buttons.
3.3B Copy One Drum Pad's Part to Another Drum Pad
Merge:
When the destination drum pad
already has a pattern
, the source pattern will be
merged with the destination pattern. Note that if the two parts contain events for the same pad
on the same beat, only one event will prevail and it will take the level of the source Pattern
event.
Sound Stacking™:
When the destination drum pad is
empty
(no recorded pattern), the source
pattern will be copied and any drum sound assigned to the destination drum pad will play the
exact same pattern as the source drum pad. This technique lets you stack multiple drum sounds
together to create monster composite sounds. See section 8.3: Sound Stacking.
1.
The IDM01 should be in Pattern mode and stopped.
2.
Select the Pattern containing the drum part to be copied.
3.
Press and hold the COPY button, and keep holding it down
until step (7). The display says
COPY TO PATT
.
4.
Tap the pad to be copied. The display shows the pad number
(e.g.,
D8
if you hit pad 8).
5.
Tap the destination pad that should hold the copied part. As long as COPY is held down, the
destination pad can still be changed by selecting another drum pad.
6.
Press PLAY. The display says
COPY DONE
.
7.
Release the COPY and PLAY buttons.
3.3C Copy a Single Drum Pad's Part to a Drum Pad in a Different Pattern
This copy function
merges
the source drum pad rhythm with the destination drum pad rhythm in a
different Pattern. To
replace
the destination rhythm with the source rhythm, first erase the destination
pad rhythm to be replaced (section 3.2C).
1.
The IDM01 should be in Pattern mode and stopped.
2.
Select the Pattern containing the drum part to be copied.
3.
Press and hold the COPY button, and keep holding it down
until step (8). The display says
COPY TO
PATT
.
4.
Enter the destination Pattern number to which the drum part should be copied.
5.
Tap the pad containing the part to be copied. The display will show the drum number (such as
D2
if
you hit pad 2).
