ES50-ES100
Effluent Pumps
OPERATION MANUAL
Dated: 11/02/2016
Document Name: ES50-ES100_OM
Page 1 of 12
Register your product at www.ionproducts.net
I
ntroductIon
Thank you for purchasing an Ion
®
Technologies
effluent pump. Take the time to read the instructions
carefully before using this appliance. We strongly
recommend that you keep this instruction manual in a
safe place for future reference.
Check the nameplate for your pump’s specification,
refer to the table list.
Be careful not to exceed the given specifications in
the use of your pump.
Each pump is individually factory tested to ensure
proper performance. Closely following these
instructions will eliminate potential operating problems
assuring years of trouble-free service.
Most accidents can be avoided by using common
sense.
IMPORTANT: Ion
®
Technologies is not responsible
for losses, injury or death resulting from failure to
observe these safety precautions, misuse, abuse
or misapplication of pumps or equipment.
M
arks
& M
eanIngs
CAUTION:
Keep the pump equipment out of
the reach of children! Warns that the failure to
follow the directions given could cause serious risk to
individuals or objects.
WARNING:
This sign warns the operator that
the failure to follow an instruction may damage
the pump and/or the system.
s
afety
W
arnIngs
CAUTION:
Read these safety warnings first
before installing, servicing, or operating any
pump.
Before Installation
This manual contains important information for the safe
use of this product. Read this manual completely and
follow the instructions carefully. Reasonable care and
safe methods relating to the installation and operation
of this product should be practiced. Check local codes
and requirements before installation.
WARNING:
Risk of Electrical Shock or
Electrocution. May result in serious injury or
death or fire hazard. Installer must disconnect all
electrical sources prior to installation, handling or
servicing. Only qualified personnel may install this
system. NFPA 70/National Electric Code (NEC) or
local codes must be followed. System must be properly
grounded according to NEC. Do not lift pump by power
cord.
WARNING:
Risk of Fire or Explosion. Do not
smoke or use open flames in or around this
system. This system is not intended for use in
hazardous locations per NFPA 70 National Electric
Code. Do not pump flammable liquids. Consult factory
for optional equipment rated for hazardous location
use.
CAUTION:
Rotating machinery,
amputation or severe lacerations can
result. Keep clear of suction and discharge
openings. DO NOT insert fingers into pump
with power connected.
Risk of serious cutting or
