4
USING THE INLCUDED HOLDERS
SLIDE HOLDER
1.
Open the film holder by lifting the tab on the bottom.
2.
Insert the slide(s) into the slide slot(s) or lay the negative over the negative slot.
3.
Close the film holder. Be sure the latch and sides of the holder are securely in place.
ROLL FILM HOLDER
1.
Lay the film holder flat.
2.
Insert one end of the roll of film in the slot on the right-hand side of the holder.
3.
Gently push/pull the roll of film through the holder to move from picture to picture.
Tip:
To avoid laying a negative in the wrong direction (which will produce a mirror image),
be sure you can correctly read the serial numbers at the top of the negative when placing
it in the holder.
Note:
If the image is scanned upside down or mirrored, you can also correct this later by
using the "flip" or "mirror" feature in Playback / Edit Mode. See "Playback / Edit Mode" in the
OPERATIONS & FEATURES section for more information.
Summary of Contents for FILM 2 SD PRO
Page 2: ......
