Figure A
Figure B
Mechanism for ionizing
wires cleaning
4
IMPORTANT PRECAUTIONS
Before you start using the purifier, please read the following important precautions and look at the
drawings of the main unit parts.
• When you take the unit from cold environment, let it stand unpacked at room temperature for sufficient period of time
(approx. 5 hours). Otherwise water vapours can condense on cool parts and after the unit is switched on, short-circuit
may cause the unit damage, destruction, and even fire.
• If the unit does not work as it should, if it was damaged mechanically or due to a fall, if it was left outdoors, or came into
contact with water (except washing the stainless parts of the filter), do not switch the unit on and contact the service
centre (see section Contacts).
• The unit belongs to the group of appliance with a Y-type connection. If the supply cable is damaged, it must be replaced by the
manufacturer, his service centre (see section Contacts), or a similarly qualified person to prevent occurrence of dangerous situation.
• Do not place the unit near open fire and fireplaces, even those that are not actually in use. Dust from the chimney and
soot can circulate through the purifier and can settle both in the unit and the room. The unit placement near lighted
candles, paraffin lamp etc. is not recommended. If you intend using candles and paraffin lamps near the unit despite of
this warning, ensure that the wick length does not exceed 6 mm to reduce the smoke production.
Figure A
shows the stainless filter which is a key part of the air purifier and ioniser. If the unit is run-
ning, the stainless filter catches dust, pollutants, allergens and irritants, and neutralizes smells. The air
purifier is designed to make no noise and requires very little time and effort for maintenance. If you
hear any noise or sounds coming from the unit, it is a general sign that the unit needs cleaning. Switch
the unit off, unplug it from the socket and follow the section Cleaning and Maintenance. If the unit still
makes noise after the stainless filter is cleaned, dried thoroughly and reinserted, switch the unit off and
unplug it from the socket. Pull the mechanism for the ionizing wires cleaning out of and into the unit
3-4 times (
Figure B
). This movement helps to remove impurities from the inner ionizing wires. To keep
the purifier in a properly functioning condition, the stainless filter and ionizing wires must be cleaned
every 4-7 days of the unit use at least (for the procedure see in section Cleaning and Maintenance).
WARNING!!!
After the stainless filter is cleaned by a common detergent (abrasives-free) and water, let it dry
thoroughly in vertical position for 24 hours before you reinsert it in the unit. Water may remain
at many places (e.g. on the stainless filter bends) and could cause the unit damage. If the stain-
less filter is damp, do not insert it in the unit. The purifier must be cleaned more frequently if it
is exposed to strong pollution.
