Machine Operation
26
Thermo-pure™ Operation (Hot Water Systems)
The Thermo-pure™ system utilises a diesel burner that heats pure water from the tank in
order to improve the cleaning results for many applications. The system can heat the water
up to 80°C (dependent upon ambient temperature). Heated pure water gives fantastic
cleaning results, powering through first cleans effortlessly and keeping you working even
when the temperature drops.
The Thermo-pure™ system draws power from the systems 12v battery.
The operator must ensure that battery is properly charged and maintained.
Automatic battery charging takes place whenever the vehicle id driven or
the filter systems is operated for tank filling. However in the event that the
system has not been operated for more than four days additional battery
charging my be required.
Operating the Thermo-pure™ system with an under charged battery may
lead to aborted starts and subsequent component failure requiring
specialist technical attention from an Ionic approved technician
The Thermo-pure™ system burns diesel drawn from either the
vehicles fuel tank or an ancillary remote tank
The Thermopure™ must only be operated in a well-ventilated area, as
carbon monoxide is present in the exhaust gas.
Operational Procedure: Hot Water
Step 1
Switch on the heater by turning the heater switch
(1) clockwise, a green light in the switch will
illuminate.
The heater will go through a controlled
start up sequence and will be heard running after
a few minutes. Coolant from the header tank will
be circulated through the heater and
then the
heat exchange
r
.
Allow the burner to run for 3
-
4
minutes before turning the hot
water delivery
pump on.
Step 2
Heated water will re-circulate back to the holding tank whenever the hot water pump is
running if the out port on the vehicle is not open.
As soon as there is demand for hot
water to
the water fed pole
the water prioritises to the pole
This feature allows the operator to pre-heat the tank prior to going on site. This is particularly
useful in winter months when it takes more energy for the heater to raise the water
temperature to the desired temperature
A further benefit during periods of extreme cold when the system may freeze is the ability to
pre-heat the water in the holding tank during the evening in order to prevent freezing of the
system.
Summary of Contents for Zero PPB
