10
© by IONTO-COMED
6. Seat depth adjustment:
The seat (4) can be extended or shortened.
)
Push the rocker switch (7) to the right to extend seat surface.
)
Keep the switch pushed until you have reached the desired position.
)
Push the rocker switch (7) to the left to shorten seat surface.
)
Keep the switch pushed until you have reached the desired position.
7. Legrest adjustment:
The legrest (5) can be adjusted independently of seat and backrest.
)
Press the left key in the 4th row (11) on the manual control to raise the legrest.
)
Press the right key in the 4th row (11) on the manual control to lower the
legrest.
8. Footrest adjustment:
The footrest (6) can be extended.
Note
The footrest must be retracted when moving the bed into the entry seat
height (lowest position).
)
Pull out footrest until desired position is reached.
)
Push footrest back in.
Save Treatment Position
1. To save the treatment position:
)
Adjust the couch to the required position.
)
Press the memory key S (14).
)
Press the programming key 1, 2 or 3 (13) after a maximum of 1 second.
An acoustic tone will sound.
)
After a maximum of 1 second press the memory key S again.
Two acoustic tones will sound.
)
Release pressure on the memory key S.
The treatment position is saved.
Note
A new treatment position can replace a previously saved position.
2. Call-up a saved treatment position:
)
Press the required program key 1, 2 or 3 (13).
Hold the key down until the bed has reached the programmed position.
Set Upholstery Heating (optional)
1. Switch the upholstery heating on:
)
Press the ON key to switch the upholstery heating on. The control panel is
located at the right side of the outer part of the back rest.
All blue LEDs (1-5) will light up.
)
Set the required temperature with the (+/–) keys of the control panel.
)
Press the (+) key (16) to increase the temperature.
The blue LEDs of the (1-5) keys will light up step by step.
