iOptron
Corp.
|
6E
Gill
Street
|
Woburn,
MA
01801
USA
|
(781)
569
‐
0200
|
Toll
Free
(866)
399
‐
4587
|
www.iOptron.com
Quick Start Guide
Step 1.
Extend tripod legs to full extension. Then lock legs
using the lock knobs on sides.
Step 3.
Secure the mount to the tripod by using the long rod
(#4). Hand tighten the rod into the bottom of the mount.
Next, slide tripod support (#2) onto bottom of rod (#4).
Position the three edges to fit against the three tripod
legs. Then hand tighten tripod lock knob (#1) to secure
the tripod support in place.
Step 4.
Attach telescope to primary dovetail holder (#10) using
primary dovetail lock (#9).
Step 5.
Set telescope to PARK POSITION. (1) Position the
mount so that the “S” is facing south. (2) The telescope
tube should be pointed directly up at the zenith. If it is
not perfectly straight then loosen the altitude lock (#13)
to adjust telescope. Once it is straight re-tighten the
altitude lock to make sure OTA is secure and will not
spin.
1)South
2)
Up
#10
#9
#4
Rod
#2
#6
#5
Step 2.
Carefully position telescope
mount onto the tripod by
aligning the three holes onto
the matching three pins.
Note: later models have the
black star knobs (right photo)
#6
