ioSafe 220+, User Manual

4. INSTALL SYNOLOGY DISKSTATION MANAGER

Synology DiskStation Manager (DSM) is a browser-based operating system which provides tools to access
and manage your ioSafe 220+. When installation is complete, you will be able to log into DSM and start
enjoying all the features of your ioSafe powered by Synology. Before getting started, please check the
following:

IMPORTANT

Your computer and your ioSafe 220+ must be connected to the same local network.

IMPORTANT

To download the latest version of DSM, Internet access must be available during
installation.

NOTE

Any ioSafe 220+ that was shipped with hard drives pre-installed already has Synology
DiskStation Manager installed. If you have drives pre-installed, continue on to 

Section 5:

Connect and Log in to Synology DiskStation Manager, page 17

.

1.

Turn on the ioSafe 220+ if it is not already powered on. It will beep once when it is ready to set up.

2.

Type in one of the following addresses into a web browser to load the Synology Web Assistant. The
status of your ioSafe 220+ should read Not Installed.

http://iosafe:5000

http://diskstation:5000

PURCHASED WITH HARD DRIVES

PURCHASED WITHOUT DRIVES

http://find.synology.com

CONNECT VIA SYNOLOGY.COM

OR

OR

ioSafe 220+ User Manual

15