PUSH 1 AND PUSH 2 OPERATION
Once you connected a normally open button as shown in FIG. 1, you can turn on and off the the load in the
following way:
PUSH interface operation
Single Click (rapid press (<1sec))
- Turns on or off the output (ON/OFF).
When the device is not connected to wifi the PUSH 1 and PUSH 2 interfaces controls both together load LOAD 1
and LOAD 2.
Once the device is joined to wifi network PUSH 1 and PUSH 2 can be used to control separately LOAD 1 and
LOAD 2 or other loads within the Newlab System (see Newlab IOT videoguide, topic devices, endpoints, groups)
5
IOTLIGHT - User Manual 2AMIN637WPS
