— APIS FUZZ (2021-06-30)
6. PUT THE PCB INTO THE ENCLOSURE
Take the nuts and washers off the audio jacks and put the PCB into the enclosure. Before
fastening the jacks make sure they are sideways (see section 3) so the board sits as low
as possible in the enclosure.
Tighten the footswitch nut. Don’t solder it just yet.
7. MOUNT THE LED
Push the LED through the bezel, until it snaps in place.
From the outside, insert the LED and bezel through the small hole next to the footswitch
and the LED's legs through the two pads in the PCB. The longer, positive leg goes to the
solder pad marked with a + sign.
8. SOLDER THE FOOTSWITCH AND LED
When all components are fastened and set in place, solder the LED and the footswitch.
Make sure the PCB sits low enough so that no component is higher than the edge of the
enclosure. It’s supposed to be a tight fit but there’s a 1-2 mm tolerance.
CONGRATULATIONS!
Give your new pedal a test drive. If everything works as expected, screw on the lid and
you’re done.
Summary of Contents for APIS FUZZ
Page 8: ...APIS FUZZ 2021 06 30...
